Interaction refers to specific actions performed on a series’ graphical elements when viewing a report.
To set up interaction for a chart series, you need:
In the component editor, go to the Series tab and open the Interaction section;
Configure the interaction settings using the available properties.
Interactions that can be customized:
Drill-down on series elements or entire series;
Hyperlinks for series values;
Tags for series values;
Tooltips for series values.
Below is a table with a list of properties that are used to customize the interaction.
Name |
Description |
Allow Series |
Enables or disables drill-down for the entire series rather than individual values. If set to True, drill-down for the whole series is allowed. If set to False, drill-down for the entire series is disabled. This is only applicable if Drill-Down Enabled is set to True. |
Allow Series Elements |
Enables or disables drill-down for individual series elements. If set to True, each graphical element can be drilled down separately. If set to False, drill-down for individual elements is disabled. This is only applicable if Drill-Down Enabled is set to True. |
Drill-Down Enabled |
Enables or disables drill-down mode. If set to True, drill-down is enabled, and the series elements are interactive in the viewer. If set to False, drill-down is disabled, and series elements are non-interactive. |
Drill-Down Page |
Specifies the report template page containing the drill-down data. |
Drill-Down Report |
Specifies an external report containing the drill-down data. |
Hyperlink Data Column |
Specifies the data column containing hyperlinks for the series’ graphical elements. |
Hyperlink |
Defines an expression that evaluates to a hyperlink for the series’ graphical elements. |
List of Hyperlink |
Specifies a hyperlink or a list of hyperlinks for the series’ graphical elements. Hyperlinks should be separated by ";". The order of hyperlinks corresponds to the order of series values. |
Tag Data Column |
Specifies the data column containing tags for the series’ graphical elements. |
Tag |
Defines an expression that evaluates to a tag for the series’ graphical elements. |
List of Tags |
Specifies a tag or a list of tags for the series’ graphical elements. Tags should be separated by ";". The order of tags corresponds to the order of series values. |
Tool Tip Data Column |
Specifies the data column containing tooltips for the series’ graphical elements. |
Tool Tip |
Defines an expression that evaluates to a tooltip for the series’ graphical elements. |
List of Tool Tips |
Specifies a tooltip or a list of tooltips for the series’ graphical elements. Tooltips should be separated by ";". The order of tooltips corresponds to the order of series values. |
Information |
Drill-down in charts does not support passing parameters. However, to filter drill-down data correctly, you can pass a tag of the graphical element or series.
|